Operator's, Organizational, Direct Support and General Support Maintenance Manual (including Repair Parts and Special Tool List): Chassis, Trailer: 3 1/2-ton, 2-wheel, M536 (2330-00-777-2957) (used with Laundry Unit, Trailer Mounted: M532); Chassis, Trailer 2 1/2 Ton, 2-wheel M537 (2330-00-777-2958) (used with Bakery Oven, Trailer Mounted: M5333); Trailer, Flat Bed: 4-ton, 4-wheel M794 (2330-00-935-0725) (used for General Purpose); Chassis, Trailer: 4-ton, 4-wheel M795 (2330-00-089-4321) (used with Dough Mixing and Make-up Unit, Trailer Mounted)
... instructions . Lack of time , lack of trained personnel , or lack of proper tools ... vehicle is reprocessed ( b below ) . b . Storage Procedure . Disassembly will be ... access to the materiel to permit inspection , servicing , and subsequent ...
C E B TO D Ly FRONT WIRING HARNESS CAB L HARNESS J FIG 2-71 N A M F H P FUEL RETURN STOPLIGHT SWITCH REAR WIRING ... diagram , front and rear wiring harnesses , XM757 truck . TO D CABL HARNESS J CEBDLUZAMFI Α H FIG 2-72. 2-137 TM 9-2320-230- ...
... Bar and Thrust Plates . ( 1 ) Install rack bar . Using ratchet wrench provided with truck , turn horizontal leveling worm shaft to position boring case in horizontal position as shown in figure 556. Using brush , coat rack bar with ...
Direct Support, General Support, and Depot Maintenance for Truck, Chassis, 5-ton, 6 X 6, M39, M39A2, M40, M40A1 ... Truck, Cargo ... Truck, Dump ... Truck, Tractor ... Truck, Tractor, Wrecker ... Truck, Van, Expansible ... Truck, Wrecker, Medium ... Truck, Bridging ... Truck, Logging, M748A1, M748A2
... bar ( U ) . ( 4 ) Position integral lever block pin ( PP ) and integral lever block ( QQ ) in the sliding bar ( fig . 145 ) . ( 5 ) Tighten hex - socket setscrew ( TT ) in end of sliding bar ( U ) . Be sure in- tegral lever block is ...
... Charts left in an instrument for several days make it impossible to analyze ... fold or scratch them . Do not write in the recording fields . Handle ... Push back the lever into its former position . The clock can also be wound when the ...
Operator's, Unit, Direct Support, and General Support Maintenance Manual (including Repair Parts and Special Tools Lists) for Trailer, Chassis, 1-1/2-ton, 2-wheel, M103A1 (NSN 2330-00-835-8629), M103A3 (NSN 2330-00-141-8052), Trailer, Cargo, 1-1/2-ton, 2-wheel ... Trailer, Tank, Water ... Trailer, Van, Shop, Folding Sides ....
... exercise as specified herein . b . Inspection . Inspection will usually be ... mi ( 40 km ) . Make several right and left 90 ° turns . Make several hard ... plan that will keep the equipment in an operational condition and reduce the ...
Unit, Direct Support, and General Support Maintenance Including Repair Parts and Special Tools List: Truck, 5-ton, 6x6, M939A2 Series (diesel) : Truck, Cargo, Dropside, 5-ton, 6x6 ... Truck, Cargo ... Truck, Dump ... Truck, Tractor ... Truck, Van, Expansible ... Truck, Medium Wrecker, 5-ton, 6x6, M936A2 (2320-01-230-0304) (EIC: BTT).
... Loctite 277 , 250 CC , CC ( 05972 ) 59241 31 O 8030-00-111-6404 SEALING COMPOUND : anaerobic , retaining , ML MIL - R - 46082 , type II , Loctite RC / 640 , 50 ml ( 05972 ) 64031 22222 333 32 F 8030-00-247-2525 SEALING COMPOUND ...
Direct Support and General Support Maintenance: Truck, 5-ton, 6x6, M939 and M939A1 Series (diesel) : Truck, Cargo, 5-ton, 6x6, Dropside ... Truck, Cargo ... Truck, Dump ... Truck, Tractor ... Truck, Van, Expansible ... Truck, Medium Wrecker, 5-ton, 6x6, M936 (2320-01-047-8754), M936A1 (2320-01-206-4078).
... loctite RC / 640 . Cex no 156 . New gasket ( 13 ) a . Coat with light film of sealing compound . Use permatex no . 2 . 157 . ) 158 . 159 . Thrust washer ( 12 ) and rear bearing cover ( 15 ) with oil seal ( 14 ) CAUTION b . Place on ...
Operator's, Organizational, Direct Support, and General Support Maintenance Manual (including Repair Parts and Special Tools Lists) for Chassis, Trailer, 5-ton, 4-wheel, GEMSS, XM979 (NSN 2330-01-170-6747), Trailer, Flatbed, 5-ton, 4-wheel ... Trailer, General Purpose, Flatbed ....
... exercise as specified herein . b . Inspection . Inspection will usually be ... mi ( 40 km ) . Make several right and left 90 ° turns . Make several hard braking ... plan that will keep equipment in an operational condition and reduce the ...
Organizational Maintenance, Truck, 5-ton, 6X6, M939 Series (diesel): Truck, Chassis: 5-ton, 6X6, M939, M940, M941, M942, M943, M944, M945 ; Truck Cargo: 5-ton, 6X6, Dropside, M923, and M925 ; Truck, Cargo: 5-ton, 6X6, M924, and M926 ; Truck, Cargo: 5-ton, 6X6, XLWB, M927, and M928 ; Truck, Dump: 5-ton, 6X6, M929, and M930 ; Truck, Tractor: 5-ton, 6X6, M931, and M932 ; Van, Expansible: 5-ton, 6X6, M934, and M935 ; Truck, Medium Wrecker: 50 Ton, 6X6, M936
Operator, Organizational, Direct Support and General Support Maintenance Manual: Compressor, Rotary, Air, Diesel Engine Driven, 250 CFM, 100 PSI, Trailer Mounted, Two Wheel (Davey Model 14M250 RPV) FSN 4310-256-9319, Component of Pneumatic Tool and Compressor Outfit, FSN 3820-950-8584
Operator, Organizational, Direct Support, and General Support Maintenance Manual (including Repair Parts and Special Tools List): Generator Sets, Diesel Engine Driven, Trailer Mounted ... AN/MJQ-25, NSN 6115-01-153-7742
... MEP - 002A Generator Sets mounted on a modified M103A3 , 1-1 / 2 ton , 2- wheel trailer . Each MEP - 002A provides 5 KW , 60 Hz , tactical utility power to the load . b . Function . The AN / MJQ - 16 Power Plant is mobile , and may be ...
Operator's, Organizational, Direct Support, and General Support Maintenance Manual: Generator Set, Diesel Engine, 100 KW, 0.8 PF, AC, 120/208-204/416V, 3 Phase, 60 Hertz, Convertible to 75 KW, 0.8 PF, AC, 110/190-220/380V, 50 Hertz, Skid Mounted (Fermont Model MB-16), FSN 6115-081-2030
... Generator Sets contain a General Electric generator in lieu of a Kato generator . 120/208 or 240/416 volts ac , 3 - phase , 4 - wire at 1800 rpm 110/190 or 220/380 volts ac , 3 - phase , 4 - wire at 1500 rpm 2. Equipment Generator ( cont ) ...
Operator, Organizational, Intermediate (field) (direct Support and General Support) and Depot Maintenance Manual: Generator Set, Gasoline Engine Driven, Skid Mounted, Tubular Frame, 10 KW, AC, 120/208 V, 3 Phase and 120/240 V, Single Phase - Less Engine : DoD Model MEP-018A ....
... AC, 120/208 V, 3 Phase and 120/240 V, Single Phase - Less Engine : DoD Model MEP-018A .... D NAVFAC P - 8-615-14 TO ... 42b 4-76 7-9 7-8 By Order of the Secretaries of the Army , the 1-7 TM 5-6115-275-14.
Operator, Organizational, Direct Support, and General Support Maintenance Manual: Generator Set, Gasoline Engine Driven, Skid Mounted, Tubular Frame, 3 Kw, 3 Phase, AC, 120/208 and 120/240 Volts, 28 V, DC (less Engine) : DOD Model MEP-016A ... Hertz 60 ... NSN 6115-00-017-8237 ...
Technical Manual, Direct and General Support and Depot Maintenance Manual: Shop Equipment, Organizational Repair, Truck Mounted (Southwest Truck Body Model SEORL) FSN 4940-169-3041, (Southwest Truck Body Model SEORLT) FSN 4940-164-4719
Shop Equipment, Organizational Repair, Truck Mounted (Southwest Truck Body Model SEORL) FSN ... free cloth . ( 2 ) Inspect voltmeter for damage and loose terminals and ... diagrams ( fig . 1-1 and 1-2 ) . 3-35 . Wiring a . General . Check ...
Operator, Organizational, Direct Support, and General Support Maintenance Manual: Lubricating and Servicing Unit, Power Operated, Trailer Mounted, 15 Cfm Compressor, Reciprocating Gasoline Engine Driven (Elliot Machine Works, Inc. Model ENG-3A), FSN 4930-842-8315
Operator's, Organizational, Direct Support, General Support, and Depot Maintenance Manual (including Repair Parts Information and Supplemental Maintenance Instructions) for Crane, Truck Mounted, Hydraulic, 25 Ton (CCE), Harnischfeger Model MT-250, Non-winterized ...
... procedure varies accordingly . The three types are : 1. Limiting speed mechanical . 2. Variable speed mechanical . 3. Hydraulic . The mechanical engine governors are identified by a ... ENGINE TUNE-UP PROCEDURES Engine Tune-Up Procedures.
Operator's, Organizational, Direct Support, General Support, and Depot Maintenance Manual (including Repair Parts Information and Supplemental Maintenance Instructions) for Crane, Truck Mounted, Hydraulic, 25 Ton (CCE), Harnischfeger Model MT-250, Non-winterized, NSN 3810-00-018-2021, Harnischfeger Model MT-250, Winterized NSN 3810
... transmission ; therefore , mechanics should road test to determine if the driver's ... overhaul . However , if the noise appears to be in the transmission try to ... trans- mission . Rattle could also be caused by exces- sive backlash in ...
This website uses cookies and collects data for optimal performance. Your continued use signifies agreement to our Privacy Policy.